Once this is done open up your garage door and remove the springs.
How to fix garage door panel.
One of the most simple fixes you can do is hammering out the bend in the door.
Unscrew the damaged panels to remove.
If it s a simple dent then this shouldn t be too hard to do.
Once this is done close the garage door holding it all the way down.
Hammer out the bend.
Slide the new panel into position and line up the track rollers and hinges with the predrilled holes in the panel.
Here are some of the best fixes available to you.
To adjust the switch there is usually a screw on the motor unit that when turned will increase or decrease how far the door descends when closing.
Removing the old panels.
This will make sure that the door does not spring open when you are working on it.
Bolt these into position with the hardware you removed earlier and your socket wrench.
Your garage panels are attached to each other and the track rollers.
Garage door seal is loose or broken.