On the e2014 the actuator lever is at an angle of 45 degrees.
How to fix my sliding door lock.
Remove the new door lock from its packaging and become familiar with all of the parts and pieces.
Then replace the bottom screw in the hole where it was affixed to the handle to prevent the latch from falling into the doorframe.
Usually its the e2014 but the only way to be absolutely sure is to loosen the two screws that hold the handle on.
Pull the cylinder lock from the door as you hold the latch with your fingers to stop it from falling into the door.
Remove the broken sliding glass door lock from the door by removing the screws that attach it to the door.
First remove the screws securing the door handle in place first with your phillips screwdriver and slide the outer latch lever out of place.
Install the locking.
Step 3 removing the screws two screws on the end of the door secure the latch.
How to fix a sliding glass door lock step 1.
You have to remove the handles to see how the small actuator lever enters the latch.
Your lock is most likely the e2014 or the e2013 shown on my sliding door lock page.
Pull the inside and outside handle off the door.