Once you are done use the sandpaper to sand out the cut edge.
How to cut pvc wall panels.
Place the paneling on the saw.
Measure the wall to check what size you need the plastic wall panels to be.
3 transfer this measurement to a sheet of fiberglass wall paneling and mark the sheet where you plan to make the cut.
Push down on the paneling as you hold it against the fence.
Measure the wall area where you plan to install your fiberglass panel.
When you ve done this use a straight edge and mark a straight line width ways where you intend to cut the panel.
Marbrex decorative internal panels for walls and cielings provide an attractive practical and cost effect.
Fitting you wall panels.
Take your saw and cut an incision at one end of the panel slowly start to cut the panel in a straight line directly through the panel following your lined mark precisely once your panel is cut down to size it is ready to be installed as recommended.
Marbrex hygienic decorative internal cladding.
If it s hard plastic you ll need to use a hacksaw.
If you want to cut the panels a stanley knife should suffice.
Installation onto walls ceilings.
Have a damp cloth on the side to wipe off excess glue.
Push the paneling forward over the blade until.
Make a pass on the panel using a metal rule and cut deeper with every cut.
If using a stanley knife simply score across the width of the panel and then it should break off in a straight line.
Carefully cut down the panel with a fine tooth handsaw.
Measure from floor to ceiling and transfer the measurements onto your panel using a pencil.
Take your saw and cut an incision at one end of the panel slowly start to cut the panel in a straight line directly through the panel following your lined mark precisely once your panel is cut down to size it is ready to be installed as recommended if you have any further questions get in touch.
Next measure out the wall panel itself with the finished side up and mark the measurements onto the surface of the panel.